Very good tutorial, the only problem I had was trying to get the first screws to thread on the nuts. With the washer on there was not quite enough threads to get a good connection.
This was super helpful in learning how to use the 3D printers. I found it incredibly important to wait and ensure that the print starts successfully so that you don’t come back later to a spaghetti of filament.
Very good tutorial, the only problem I had was trying to get the first screws to thread on the nuts. With the washer on there was not quite enough threads to get a good connection.
This was super helpful in learning how to use the 3D printers. I found it incredibly important to wait and ensure that the print starts successfully so that you don’t come back later to a spaghetti of filament.
This is a good introduction into the use of solidworks