Wireless Projection in the Maker-E

Find the application EasyMP Network Project Utility on Epson website using this link.

Choose the appropriate system type (as shown in the 2nd photo).

From Utilities, download the program shown after specifying the installed operating system.

Or use this link to download the program if you are using a Maker-E computer.

Pull down the projector screen from above the white board.

Use the remote control (usually located on the white board shelf) to turn on the projector.

Launch EasyMP Network Projection on your device.

Choose "Advanced Connection Mode" when prompted.

Click the Manual Search button and enter the following IP address: 134.82.135.238

Click the check box next to "MAKER-E_COMMON" and click Connect button.

You are now connected to the projector.

You may need to toggle the projector input to LAN by clicking the Projector Control button on your device. Then, click Switch PC Source button several times until LAN is selected and your desktop is projected.

Note that there may be a delay until your image is projected.

When you are finished, close EasyMP application.

Turn off the projector using the remote.

Pull the projector screen back up.