Skip to main content

1.00.1

Minor Versionm

by Owen Meng

Introduction

Published by Ryder R. Nance with contributions from Matt P. Lamparter.

  1. Begin by plugging your USB flash drive into the USB port on the front of the oscilloscope.
    • Begin by plugging your USB flash drive into the USB port on the front of the oscilloscope.

    • Note that your drive should be formatted as FAT32 (not NTFS, HFS+, APFS, etc.) Failure to format your USB drive properly will result in an inability for the oscilloscope to write to the drive.

  2. Once you are satisfied with the waveform displayed on the screen, press the Save/Recall Button on the front of the oscilloscope. Push the Save softkey as displayed on the screen. Set the file format to CSV
    • Once you are satisfied with the waveform displayed on the screen, press the Save/Recall Button on the front of the oscilloscope.

    • Push the Save softkey as displayed on the screen.

    • Set the file format to CSV

    • You can also:

    • View the file name

    • Change the file name

    • Change the save location (make sure this is set to your USB drive. The scope will default to save in the root folder in the USB drive but you can change this)

    • You can now use this to graph your data in Excel or Matlab

Finish Line

Ryder R. Nance

Member since: 08/16/2017

14 Guides authored

Team

Micromanipulator Member of Micromanipulator

Community

1 Member

14 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 42